I realized that the insides of these big panels were hugely exposed and needed smoothing out. Lucky for me I hadn't glued them together yet (hooray for test fitting). Here's what I'm talking about:
If you look inside there you can see little circles, pointed out on the right side in this pic (you might need to angle your monitor down to see it):
The arrow on the left is pointing out a rough edge I'll need to polish too.
On this pic you can see what this part looks like before and after smoothing out:
and here's a little movie, with actual narration no less, that shows you how to quickly and relatively painlessly clean up parts that show their "wrong" sides like this and other shoulder armors so often do:
Even if I was doing "no-paint" this would look good now. But I'm painting this time around, so stay tuned :)
No comments:
Post a Comment